!!!! check out the customizable version - click here !!!!

I have made this simple stand for a commonly available, cheap hygro- and temperature-sensor. The stand is angled under 60 degrees and currently serves me well on my desk to show me the room temperature and humidity of my office.

Update 2024-05-28: I have added a remix to this model with a parametric (makerworld customizable) design. You can adjust the angle, thickness, etc. from this site. You can find it here.

Update 2024-02-18: Stand v2 added, which should have a better fit and has cutouts for the lips of the hygrometer.

By the way, the texture on the front of my print is the result of using a textured PEI plate.

What you additionally need:

• Sensor, which can be purchased here, or anywhere similar (I think aliexpress carries them as well).

I used the following settings to print in 1.75 PLA with 0.4 nozzle:

Leave a like, make or remix as you like!