Model Update (2025-02-22):

The version uploaded before February 22nd was missing the flashlight hole. Apologies to those who have already downloaded and printed the model.

The issue has now been fixed, and the updated version with the correct opening is available for download. Thank you for your understanding! 🙏

Special thanks to iTech designs for bringing this to my attention! 🙌

Features:

• Buttons and camera protector colors are fully customizable.
• Supports PLA, PETG, and TPU printing (showcase model printed in PLA).
• Use Arachne wall generator with a 0.4mm nozzle to prevent gaps in fine details (<0.45mm).
• Physically tested with an iPhone prototype for a precise fit.
• Camera button area is fragile—install carefully.

• PLA/PETG cases may break when removing the phone—tear open from the camera button area if needed.

  

• The installation method for the 16  camera protector is different from what is shown in the video. Please refer to the following installation instructions.

  

• Due to material shrinkage, the buttons may fit too tightly depending on the filament used. If this happens, try carefully sanding the top edge of the button hole with a small file to remove any leftover support material, or scale the button’s X axis to around 98% (as shown below) before printing for a better fit.

  

• Do not remove the outer skirt on the button — it’s designed to prevent the button from falling out.

Other Cases