Here's a 4 color print for Jurassic Park and dinosaur fans! 

There are lots of lines and details in this print, which means it will take longer to print, but the end result is awesome. 

Also pictured below is my Dino Wave print, exclusively available on my Patreon. 

For another dino print, you can find my T Rex Island here: [https://makerworld.com/en/models/818808#profileId-761557](https://makerworld.com/en/models/818808#profileId-761557)

----------------------------

My designs are for personal printing use only. 

A commercial license to sell printed copies of my Makerworld Designs is available. 

I also post exclusive designs on my Patreon. A commercial license to sell BOTH my Makerworld and Patreon files can be found here: [https://www.patreon.com/busykikibee](https://www.patreon.com/busykikibee)

----------------------------

Pictured frame, stand, or puzzle box can be found in Frames and Functional items over @CanadianGamer [https://makerworld.com/@CanadianGamer/collections/1027330](https://makerworld.com/@CanadianGamer/collections/1027330)

All photos you see are of actual prints of my design. If you use the same filament and colors, you can expect the same result as you see in the photos. The 3mf file is AMS ready to slice and print with the height range modifier and layers prepared for you. If you are using the STL to slice and print the file, be sure to apply color swaps by their mm height and use the height modifications and infill instructions as per the directions provided. During slicing, you might get an error message about floating regions, which you can safely ignore. Finally, if you wish to scale the design, do NOT scale the Z axis. Happy printing! 

Project: Dino Claws
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.64mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

This print uses 4 unique filaments
PLA BambuLab Basic Black 
PLA BambuLab Basic Maroon Red
PLA BambuLab Basic Blue Gray
PLA BambuLab Matte Desert Tan 

Swap Instructions:
Start with Black
At 1.04mm swap to Maroon Red
At 1.28mm swap to Blue Gray
At 1.76mm swap to Desert Tan for the rest.