This sliding fidget toy uses rubber bands either from home, Maker's Supply, or the Maker's Beginner Kit! It is perfect to sooth all of your fidgeting needs. for assembly, please refer to the guide I have provided below. ⬇️

-Enjoy! :)

To make assembly a whole lot easier, please check out my specially made assembly tool! 
[https://makerworld.com/en/models/1119757#profileId-1117895](https://makerworld.com/en/models/1119757#profileId-1117895)

Step:1

Put the rubber band into the assembly tool and slide it through 1 of the 2 end caps.

Step:2

Slide the assembly tool through the main body and hook it through the 2 rubber bands. Then, pull it through and clip it on. The end cap only goes on 1 way so don't force it if it doesn't want to go in. Repeat for the other side.

Step:3

Put the slider on the smallest side of the body and grab the tiny clip. Insert the clip onto the TOP notch of the slider. NOT the bottom. You can use the bottom side of the assembly tool to get it all the way in there.

Step:4

Hook the assembly tool into both sides of 1 of the rubber bands and slide it onto the far side of the slider. To get it off, tension the rubber band and twist the assembly tool carefully off. Repeat for the other side.

Step:5

Enjoy your new fidget! If you want, you can take off 1 of the rubber bands to make an entirely different launcher type fidget. I will say that there isn't really an exact way to use it, so be creative and have fun!