AC Infinity Controller Pro 45 degree wall mount. 

I needed a single gang wall mount for my controller in the utility closet after replacing the ceiling vent fan with an AC Infinity Cloudline Pro. Dropped the UIS cord from the attic into the single gang wall box and plugs directly into the back of the controller, which is held in place with the built-in magnetic backing. The plate is secured with standard screws into the gang box. The mount is press-fit for ease of wiring and connecting. The mount is angled at 45 degrees. This allows me to mount in a direction that is easier to see from the front and when working from the side. It has a sensor probe mount on the side and all wires/cables easily fit within the housing. 

• Print as is - no supports needed (PLA or PETG)
• You will need two 10x3 mm magnets (press-fit) - It may work with smaller magnets (glued) or just metal washers if you do not have magnets, since the controller has a built-in magnetic backing.