When scooping coffee for my reusable K-Pod the regular coffee scoop never fit the bill for convenience, from never getting the right amount of coffee grounds to the little pile of coffee grounds that inevitably falls off the handle and onto the counter making a mess to clean up first thing in the morning, such an inconvenience am I right? Well introducing my inception of the perfect scoop for reusable K-Cups / K-Pods!

The Bevel at the top can be used to place the pod on top of the scoop before turning it over to fill the pod with the perfect amount of coffee grounds and the ridge that extends from the handle to the scoop ensures all the coffee grounds that would normally end up on the counter stay in the bag or container and off your counter! the handle should be long enough but if anyone would like a longer handle just let me know in the comments! The one design constraint i wanted to make sure of was that this scoop did not require supports which is why i chose to have a flat section on the scoop so everything prints at a 45 degree angle so there is no fussing with support removal and no wasted material, just ensure your plate is clean or use a brim because adhesion is a must! 

If printing on the A1 or A1 Mini be sure to print it at .2mm layer height as anything less will cause the nozzle to collide with the print because of the vibration from the bed moving on the y axis. On X/P series printers feel free to go down to .12mm if you desire as the bed doesn't move and they are much more stable!