Overview: A clean and simple way to display the popular Hygrometer/Thermometer found on Amazon and Maker's Supply. We've all got a handful of left over hygrometers not being used in our AMS so why not neatly display them around the house! This model follows the curves of the hygrometer and turns it into an elegant item to display on any desk or bench.

Fast and easy to print in any material, this print suits hygrometers with the mounting clips at both 0 and 20 degrees. The face diameter of my hygrometer is 45mm, while the inside cutout is 41mm.

Print Settings: Uses less than 10g of filament! My model was printed at 0.08mm in 40 minutes. 0.12mm layer height will print in 30 minutes.

A link to my alternative hygrometer design is here! [https://makerworld.com/en/models/1148780-thermometer-hygrometer-stand#profileId-1152650](https://makerworld.com/en/models/1148780-thermometer-hygrometer-stand#profileId-1152650)

If you like this print, please leave a comment or a boost!