Meshtastic stationary node:

• Raspberry Pi Zero 2 (soldered longer gold pins - 17mm; regular are too short)
• Waveshare SX1262 LoRaWAN Node Module Expansion Board ( [https://www.waveshare.com/sx1262-lorawan-hat.htm](https://www.waveshare.com/sx1262-lorawan-hat.htm) )
• Waveshare 1.44" LCD hat ( [https://www.waveshare.com/1.44inch-lcd-hat.htm](https://www.waveshare.com/1.44inch-lcd-hat.htm) )
• GPS antenna (like from [https://s.click.aliexpress.com/e/_DCeU5lh](https://s.click.aliexpress.com/e/_DCeU5lh) )
• UFL – SMA female connector ( [https://s.click.aliexpress.com/e/_DlYPJT9](https://s.click.aliexpress.com/e/_DlYPJT9) )
• Sirio SO 868-915-2 W/Cable antenna ( [https://www.sirioantenne.it/en/products/uhf/so-868-915-2](https://www.sirioantenne.it/en/products/uhf/so-868-915-2) )

Printed from PETG, no supports. Print 8x between-boards-pin.

GPS antenna mounted with double sided tape.

Fusion source file is available.

raspberry pi /boot/firmware/config.txt:

dtparam=spi=on
dtoverlay=spi0-0cs
enable_uart=1

Config pieces (config.yaml):

Lora:
  Module: sx1262  # Waveshare SX126X XXXM
  DIO2_AS_RF_SWITCH: true
  CS: 21
  IRQ: 16
  Busy: 20
  Reset: 18

GPIO:
 User: 5

GPS:
 SerialPath: /dev/ttyS0

Display:
### Waveshare 1.44inch LCD HAT
 Panel: ST7735S
 CS: 8         #Chip Select
 DC: 25        # Data/Command pin
 Backlight: 24
 Width: 128
 Height: 128
 Reset: 27
 OffsetX: 2
 OffsetY: 30

Thank you for your support. If you found the project helpful, please buy me a coffee and see you in the next projects.