Thank you for considering my PS5 Controller and Headset Mount model!

Update 28.12.2025: I've added a lip for the headrest part as per suggestion by a user. Also I've simplified the geometry slightly in order for support to print a little easier and to have a nicer surface finish on supported areas.

I'm using a cable Headset with my PS5 Controller but couldn't find an appropriate mount to store both at the same time. I wanted to pick up the set and start gaming without fussing about with the cable.

That's why I took Vlastimil's idea and redesigned the spacing between controller and headset part, removed material for the cable plug and most importantly added extrusions on the backside. This is to ensure that the controller trigger buttons won't collide with the wall. The controller sits much better now! The model uses double sided tape for mounting. If you need screw holes 1.) utilize the .STEP file attached to create your own or 2.) drop me a line and I will create a model for you!

Important note: The print profile doesn't include support material but just PLA for support. This has worked fine for me but it does leave the supported surface a bit rough. It does not impact function though. The cable won't get caught. You could also take a nail file and sand any imperfections.