Creates a place to mount a 1 3/8 inch bubble level to your camera. Remixed from the model Hot Shoe Cover by Skewed Perception.

It is important to calibrate the bubble by leveling the camera first and then gluing the level to the printed mount when it is attached to the camera. Not all levels except perhaps very expensive ones are actually level. I used hot melt glue but next time I will use an epoxy putty so that it gives me more time to calibrate the level before the glue solidifies.

Print on its side with the rounded part facing up so that you need no supports.

[https://www.homehardware.ca/en/bullseye-surface-level/p/1037050?page=search-results%20page](https://www.homehardware.ca/en/bullseye-surface-level/p/1037050?page=search-results%20page)