Magnetic/screw clamp/holder/guide for wires/cables etc for light weight application

- Attach using magnets or screw
- Fits a magnet of 6mm diameter and 3mm height
- Three different magnet tolerances (print profiles): 
    - v2 0.05mm. Snug fit (Recommended)

    - v3 0.1mm. Just fits (Might need to be glued down) 
- Three different sizes (Plates). 

- Enable brim if you have bed adhesion issues.

Tiny
The overall diameter is about 12mm
Fits a cable/wire etc of ~4mm
Filament usage: 1.32g
Print time: 15mins on P1S

Small
The overall diameter is about 12mm
Fits a cable/wire etc of ~4mm
Filament usage: 1.64g
Print time: 18mins on P1S

Large
The overall diameter is about 14mm
Fits a cable/wire etc of ~7mm
Filament usage: 2g
Print time: 18mins on P1S