A little wind turbine you can take apart and carry with you.

Features:

• Spinning rotor
• Blade pitch adjustable
• dismountable
• carry box and stand

Attention after printing for the threads:

The two tower sections connect via an M8 thread. In this size the print is usually difficult. I recommend recutting the threads of the hole after printing. Clean out the hole very good afer cutting. No debris should remain and cause damage to the threads of the bottom tower section.

For the first time screwing them together be careful and turn only a quarter or half turn, than back and work you way forward until it fits nicely.

Assembly:

1. For assembly you need 8 magnets with the size of 3x6 mm. (height x width)
2. And a little bit of glue to attach the nacelle to the upper tower section.

Transparency hint

The original turbine was developed in the wind energy engineering master program of the university of applied science Flensburg (Germany) in 2025.

This is the little model a friend and me did to provide everyone a nice memory to take home.