Here we have a cover for a full light switch incase you have a light switch which has to be constantly ON or OFF !

I looked at many of my light switches and noticed that every single one of them isn't strait installed nor properly aligned.

I haven't noticed until now and I'm pretty sure that 85% of the people who use them daily don't notice that either.

Out of that reason this designed is a bit bigger, 5mm longer to be exact. (I might change it or upload a new design) 

Usually with any of my Designs I try to avoid supports.

Unfortunately with this Design it won't be possible and has to be printed with supports.

For the Installation I used a little drop of Hot glue on the light switch. 

→ holds very strong!

→ can be removed 

→ doesn't damage anything

Here you will find my other two light switch covers: (click on them to get to the print profile)