Wall Mount for Star Wars The Black Series Helmets & Marvel Legends Helmets

There are many helmet wall mount designs out there already but none of them offer the flexibility of this design

• No fixed height - Uses a 19mm tube commonly used for wardrobe rails cut to length to suit each helmet
  In the UK the tube can be sourced from Screwfix 1.83m long for just over £6
  [https://www.screwfix.com/p/essentials-tube-polished-stainless-steel-1830mm-x-19mm/191te](https://www.screwfix.com/p/essentials-tube-polished-stainless-steel-1830mm-x-19mm/191te)
   
• Easy to level - Tube end cap can be swiveled to get a perfect balance
   
• Optional top cap - Triangular top cap gives further support when needed and can be useful for tilting helmets forward and backward by rotating the point of the triangle to the front or to the back.
   
• Close to wall angle - The wall mount is angled closer to the wall than most other designs reducing the stress on the printed part and on your wall! The close to wall angle is perfect for the more flat backed helmets like the Mandalorian and Boba Fett's.
   
• Uses minimal filament compared to other designs that also need to print the supporting arm.

Print profile contains the wall mount, tube end and optional top cap, to be printed in ABS or ASA.
I do not recommend printing in PLA if the mount is to be situated where sunlight could potentially warp the PLA.

See my other designs for a matching Star Wars The Black Series Lightsaber mount