I created this model because I wanted to add some barbed wire to my tabletop. This system uses a jig that takes 1mm wire and perfectly spirals it to look like barbed wire on a miniature scale. Assembly is required.

ASSEMBLY INSTRUCTIONS

Paint everything before gluing.

1. Glue an End Piece to one side of the Rod. Make sure it is perfectly centered. Wait for the glue to dry.
2. Insert your barbed wire coil onto the Rod.
3. Glue your other End Piece to the other end of the Rod. Make sure it is centered as well. You can check leveling by laying it against a table.
4. Sit the whole unit up where it is laying on the face of the End Piece that you glued first.
5. Let the glue dry.
6. Enjoy!