Plate 1 contains the loop part (or whatever this is called) of the original zipper puller. 

Plate 2 contains the Ghost puller. The Ghost has been filled and then a zipper hole has been cut out to make the zipper puller fit.

Plate 3 contains a version of the loop part that is slightly thicker. Measure or print and test if it fits your zipper. It might be sturdier than the version on Plate 1.

You either need to print Plate 1 OR Plate 3.

This is the zipper puller I remixed for this model:

[https://makerworld.com/en/models/121395?from=search#profileId-130569](https://makerworld.com/en/models/121395?from=search#profileId-130569) 

The “Ghost” I remodeled from being a keyhanger to being a zipper puller: [https://makerworld.com/en/models/517308?from=search#profileId-433605](https://makerworld.com/en/models/517308?from=search#profileId-433605)

Link to original license of both files: [https://creativecommons.org/licenses/by-nc-sa/4.0/](https://creativecommons.org/licenses/by-nc-sa/4.0/)

If you have adhesion problems with this print, please add a brim.

I suggest printing in PETG for better durability and the ability to have the zipper washed in the washing machine. PLA might break during assembly.

If the loop part does not fit into the ghost, you might need to rasp the ghost entrance a little bit. If the loop part is too loose in the ghost, add a drop of glue.

If you like you can glue some googly eyes on :-) I had a pack with different sized eyes from Butinette.