Nintendo Switch Controller Vertical Charging Stand

The perfect way to store your controllers when not gaming!

This stand allows you to simultaneously charge two Nintendo Switch Pro Controllers or Nintendo Switch Joy-Cons (through the Joy-con Charging Grip) while minimizing space thanks to the vertical disposition!

The stand requires two USB C charging cables to be connected to the switch USB ports or a power adapter. USB A to C splitter cable could also be used (beware that charging speeds will be slower!).

Printing instructions:

Print horizontally, flat on one of the two sides to achieve the best surface. Supports are not needed but may improve the holes' quality.

Assembly instructions:

To assemble simply slide the cable from the back while holding the connector vertically. Once through, rotate it 90 degrees and pull it back until stuck!

The connector hole is 20mm deep, if the USB C end of your cable is shorter than this you can also print the dedicated spacer, scaling it along the Z-axis as needed. To use it, mount it to the cable as shown in the last picture before pulling the cable in the hole.

ATTENTION: the cable may be stuck inside the hole after you pull it, to remove it push it from the back with something such as a screwdriver.

Descrição

Printing instructions:

Assembly instructions: