Ir para conteúdo
3DFinder
Entrar

Você está no 3DFinder

Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.

Buscar mais como este
Modelo 3D Kinfire Delve - Insert por David A no MakerWorld

Descrição

An insert for the standalone Kinfire Delve games: Vainglory's Grotto, Scorn's Stockade, and Callous' Lab.

Features

  • Quick setup: pull out the token tray and cards, and you're ready to start.
  • Supports sleeved cards with outer dimensions of 94mm x 69mm.
    • Each card well is 32.5mm deep, so full stack of cards should be 65mm or less.
  • Token tray doubles as a holder for the Health die during gameplay.
  • Tokens don't need to be carefully stacked or lined up, just dump them in the tray wells.
  • Trays have rounded bottoms to make it easier to pull out tokens.
  • Cards are slightly raised in their wells to make it easier to pull out the decks.
  • Recessed area for the Proof of Purchase chit.
  • Plenty of space for fingers.
  • Notches to keep the rulebook in place.
  • All components are held snugly against the lid, and nothing—not even the cards—can accidentally slide out of its spot even if the box is stored vertically, shaken, or flipped upside down.

Printing

  • 0.4mm nozzle
  • 0.2mm layer height
  • Lightning infill pattern
  • 0 bottom shell layers (on Main Tray only)
  • Basic PLA

Those are the settings I used, and it came out great. The Lightning infill and Main Tray's 0 bottom shell layers save ~16.5g (~19%) of filament.

Assembly

Pop the two pieces off the print bed and put the Main Tray in the box. Cards go in the two wells, skill dice in between them, and the Proof of Purchase down in its spot. For the Token Tray, the progress tokens are split between the two sides, and the health die sits in its spot. Be sure to set it with the 10 facing up so you're ready to start your next game (or with the 8 if you're playing on Hard Mode, you madlad). Token Tray goes into the gap on top of the Proof of Purchase. Finally, the rulebook sits in roughly the center, between the notches, to keep it in place and allow the health die to sit flush with the lid.

Usage

When you're ready to play, pull out the Token Tray and set it nearby, oriented so the health die faces you. Pull out the skill dice and cards from the Main Tray, and set up the game normally.

MakerWorld

Kinfire Delve - Insert

Publicado em 26 de jan de 2025

51
Curtidas
321
Downloads
161
Coleções
262
Impressões
Categoria Board Games
Tags
board games boardgames insert organizer tabletop games tabletop board game insert board game organizer kinfire tray board game board game accessories
Licença BY-NC-SA
Ver no MakerWorld (abre em nova aba)