Another Ice Scoop.

I like to think this one is a little better than others, but I'm a bit biased.

This model uses supports just under the handle itself so unless you're using an interface material there will likely be a little texture underneath which isn't entirely noticeable.

It also has a contoured handle for a comfortable grip. And a size that should allow the ice to slide into most glasses easily.

Of course, you're welcome to use the scoop for just about anything. 

I printed with a translucent PETG because I thought it looked interesting. It's strong enough that should perform well with PLA as well.

The bottom has an angle to it as curves don't tend to print as well, which was the discontent I had with another model I was using, the print quality bothered me.