Cute little plant support stake with a 7 hearts design, to add a little fun to your plants, whilst supporting them at the same time! This is my first ever design, and to be honest, I'm really happy with it. It makes my plants look super cute, and it does the job of supporting them very well. 

I designed it with quite long ‘legs’, as many that I've seen are quite short, and so less stable. The open nature of the hearts allows you to tie or clip parts of your plant to it for additional support, but I just tucked some leaves through the hearts! 

Print in one colour, or change filament at layer 36 to get the two-colour print. AMS not required. The 3 red hearts are thicker, so changing the filament at layer 36 (or later) will only print on those 3 hearts.

Stake is 30cm tall top to bottom and 12cm wide. 

“Legs” are 13cm long, with a point at the end for easy insertion into the pot.

I used PLA for this print, and it is more than sufficient. Generic PLA settings on Bambu slicer.