Introducing The Fidget Spinner Ring Collection

This is a set of 6 Fidget Spinner Rings.

For 6 More Rings check out Pt. 2 here: [https://makerworld.com/en/models/2976386-fidget-spinner-ring-collection-pt-2#profileId-3338813](https://makerworld.com/en/models/2976386-fidget-spinner-ring-collection-pt-2#profileId-3338813)

All rings Available in US sizes 5 - 15.

Sizing

US Size | Inner Diameter (mm)

5            | 15.7 mm

6            | 16.5 mm

7            | 17.3 mm

8            | 18.1 mm

9            | 19.0 mm

10          | 19.8 mm

11          | 20.6 mm

12          | 21.4 mm

13          | 22.2 mm

14          | 23 mm

15          | 23.8 mm

Printing

• Print Profiles attached contain all sizes and are pre colored.
• Rings print in 2 pieces. Easily snap them together as shown in the 3rd image.
• Print Profiles print each part separately to save time and filament with AMS.
• Create your own colorway by matching different filament to each color group.
• Use your fanciest or shiniest filaments for best results.
• All rings use the AMS for multicolor, but can be made single color.
• Rings are designed to be printed at a 0.2mm layer height with a 0.4mm nozzle.
• 0.2mm nozzle not needed, but may give better results at the expense of time.
• Printing times are around 20 minutes (0.2mm layer height with a 0.4mm nozzle).
• Rings may run tight due to interior roughness and print tolerances, be prepared to sand the inside or go up a size.
• For best results remove any bumps around the z seems or elephants foot with a deburring tool, knife, or sand paper.

Please share your Colorways!