Summary

Here are the buttons i used: [https://www.amazon.com/DAOKI-Switch-Momentary-Button-Arduino/dp/B07YKH3TDR/ref=sr_1_6?dchild=1&keywords=Momentary+Push+Button+Micro+Limit+Switch&qid=1629005820&sr=8-6](https://www.amazon.com/DAOKI-Switch-Momentary-Button-Arduino/dp/B07YKH3TDR/ref=sr_1_6?dchild=1&keywords=Momentary+Push+Button+Micro+Limit+Switch&qid=1629005820&sr=8-6)

Machine screws mount the buttons to the back controller shell.
The switches can be wired by soldering them on the motherboard test traces (use the smallest wire gauge you have) which should be labeled already.
Use a piece of 1.75mm printer filament as the axle for the button

Print Settings

Rafts:

Yes

                                            Supports:                      
Yes

Resolution:

0.1 layer heigth

                                            Infill:                      
55

Filament: esun PLA

                    
                        Notes:                     
the button will be a lot quieter if you use a higher infill.

Descrição

Summary

Print Settings

GameCube controller back buttons/paddles