Folding Phone Stand Version 2

Folding Phone Stand - Version 2

I was never quite happy with the finished product of ShapeMaven's beloved print-in-place phone stand, so I have redesigned it to maximise quality and usability!

How does this differ from V1?

More aesthetic design
More seamless use
- Inner latch does get caught when erecting phone stand
- Tab at the top to open, rather than pushing from the back
Inner section doesn't swing the wrong way
Small clips on the top of middle section to keep phone stand closed during storage and travel
Better curved base for a sturdier and more versatile hold
Added one extra level of adjustment

There's now a longer version!

A few of you really liked this phone stand, but thought it couldn't benefit greatly from being slightly longer. So here's a release with an additional 20mm in length, along with two more levels of adjustment and a slightly more stable base hook! See here for listing: Folding Phone Stand - Long

Features

🔹Print in Place
🔹Folds flat for travel and storage convenience.
🔹Large base suitable for most phones.
🔹7 levels of adjustment.

3D Printing Advice

🔸Tried and tested with PLA, PETG and ASA with good results.
🔸No supports required
🔸Entirely print in place
🔸Prints upright (same orientation as photos)

Announcement

Please note that this free-to-download version is for personal use only, so the license does not permit adaptations/derivatives, commercial use or any sharing or distributing either physically or digitally. Having said all that, a commercial license, as well as further variations, support, custom personalisation's and more are available through my Patreon:

ShapeMaven Patreon

If you're feeling extra generous, a like and/or follow on my Facebook or insta would be very much appreciated!

Happy printing my fellow enthusiasts!

Descrição