Stripped down to bare bones, add to your big bricks collection with this 500% scale Skeleton based on the popular brick company minifig! This model prints with not support and is fun to assemble! 

UPDATE 5-27-25!! Made screw for head easier to assemble and attached neck to torso making assembly easier.

To assemble

Slide the face inserts into the face at an angle, then screw the neck into the head. I find sometimes if the threads get a little tight, you can work the threads back and forth to allow smoother threading.

Now take the arm part as shown. The arms are mirrored so that the pins can be on the inside so be sure to match them side to side and the clips are rotated 90 degrees. Slip the elbow connector into each end of the elbows and use the pins to lock them together.

Take the torso halves and place them together. I usually start the neck pin and then slide the arms and legs on before inserting the locking pins at the arm and leg pivots. The short pins go in the arms and the long in the legs. Seat the neck pin fully, the bigger part should be pretty snug. You can put the arms and legs on after assembling the body if you like.