Organize your drink packets all in one place! Using the optional base, the entire organizer rotates for ease of use. This optional (but recommended) base requires the use of a standard 608 bearing.

Print Settings

The main organizer requires no special settings. The base should be printed with a high infill percentage. The extra weight will help keep the base steady while the organizer is spinning. I also recommend ironing the top surfaces of the base that will make contact with top section.

Assembly Instructions

Press a 608 bearing into the hole on the bottom of the organizer. This should be a tight fit. Set the organizer on the base so that everything aligns the same as below:

Note: The connection between the base and the bearing is not a tight fit. This allows you to remove the base at anytime or swap it out for a different color.

The following filaments were used in the pictures above:

• Bambu Lab Galaxy Nebulae PLA