This is a rework/remix that a) Allows the top to rotate b) adds Davros ( see as a replacement [https://cults3d.com/en/3d-model/game/davros-classic-design](https://cults3d.com/en/3d-model/game/davros-classic-design)) c) Allows the top/bottom to be attached using magnets if preferred. I also made the eye stalk, exterminator (?) and sucker thicker as the original proved to be very fragile. Ialso split the model up on to plates which allows more customisation of colours with the use of the AMS.

 Two points: The multi-coloured Daleks can produce a lot of waste. I have combined two colours on the first plate but by all means add a second plate and move one colour to a new plate. Secondly, the eye stalk is quite fragile and can break when removing from the plate and removing the supports. I made this as large as possible without looking weird on the end model. Maybe print a few!

The original Davros was designed to be made on a resin printer, but it worked fine with FDM.

I made all these using PLA with a 0.4mm hot end and 0.2mm layer height.